snmp trap link-status

Syntax

• default snmp trap link-status

• default snmp trap link-status port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

• no snmp trap link-status

• no snmp trap link-status port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

• snmp trap link-status

• snmp trap link-status enable

• snmp trap link-status port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

• snmp trap link-status port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} enable

Command Parameters

enable

Enables or disables link-trap status for the port.

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

The default is enabled.

Command Mode

GigabitEthernet Interface Configuration